Wavetek 3ST Specifiche Scaricare il pdf (Pagina 69)

4-45

Characteristic Trunk Head Extender Fiber Field

1 Area yes yes yes yes

2 Amp Id yes yes yes

3 Power Configuration yes yes yes

4 Feeder Maker Config yes yes yes

5 Trunk Termination yes yes yes

6 Voltage Setting yes yes yes

7 Rev Pad yes yes yes

8 Rev Equalizer yes yes yes

9 Fwd Pad yes yes

10 Fwd Equalizer yes yes

Editing of location files is done by pressing the Edit soft key. The

optional fields will be enabled or disabled according to the location

type selected (see table above).

Use the Up and Down arrow soft keys to scroll to the desired param-

eter. Use the UP and DOWN arrow keys or the numeric entry keypad

to enter the desired value. Once all the desired parameters have been

edited, press the OK soft key.

The Delete soft key is used to delete a specific location file.

4.13.2 How To Perform An Auto Test

The Auto Test mode provides automated FCC 24 hour testing

capabilities. Video & audio carrier levels will be measured for each

enabled channel. Additionally, the following can be selectively

measured for each channel: C/N, Hum, and Modulation. See Section

4.3.3 How To Setup Your Channel Plan for instructions on how to

enable these individual measurements. Tests can be made immedi-

ately or at timed intervals, with the instrument sleeping between

tests to conserve battery life. Upon test completion, the test results

can be viewed on the LCD display before printing or downloading to

a PC.

Press the Perform Auto Test soft key to enter the Auto test mode.

The instrument provides a step-by-step procedure on how to perform

an Auto Test.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 101 102

Nessun commento

Wavetek 3ST Specifiche Pagina 69